Find the studs and position the vanity locate the wall studs and mark them a little higher than the top of the new vanity.
Changing bathroom vanity top.
Disconnect the drain pipes from the existing sink unit using a pipe.
Measure the dimensions of the existing vanity top using a tape measure.
If the old vanity is marble or granite it will not be screwed on.
Start by cutting off water and disconnecting and removing old fixtures.
Set the vanity in place.
Mark the placement of the new vanity s screw holes.
Measure the vanity base with a tape measure and write down the measurements.
Remove screws underneath cabinet.
Measure for the new vanity top.
Cut caulk between backsplash and vanity with utility knife.
Remove the doors from the vanity cabinet using a screwdriver to make it easier to work.
Figure out the center every bathroom sink or vanity top has three holes cut at.
Buy your new vanity top according to these measurements.
A custom vanity top maker based in georgia will design vanity tops as long as 140 inches and as deep as 30 inches.