Change Awning Roller

For more information call 5.

Change awning roller.

Use the awning rod to pull the awning away from the rv by 1 foot 30 cm. This is because the lights will be covered by the unrolled awning fabric if it s not fully extended. If a new roller cover assembly is being installed a 1 8 hole will need to be drilled 1 1 2 to 2 from end of the main slat for the pop rivets. You can easily replace your old beat up worn torn roll up awning fabric without replacing the hardware.

Flip the control lever to extend the awning by 1 foot 30 cm. Start by flipping the control lever on the right side of the roller tube as though you re preparing to fully extend the awning. Our universal 13 oz. Special discount for rvgeeks viewers.

Check that both arms are resting on the ground so that the fabric is unrolled about 1 foot 0 30 m from the awning. The end of the awning you will only be able to use the lights when the awning is fully extended. Find the control lever on the right side of the awning s roller tube. Flip it just like you would when fully extending the awning.

To prevent damage be sure to remove any burrs left by the drill. Rv awning replacement fabric will fit awnings that use a 1 4 size rope at the awning rail almost all use this and will fit a range of roller tube rope sizes 5 32 3 16 1 4 rope sets included. Install two pop rivets in the main slat d on both ends to prevent the fabric from shifting in roller cover.