Fence tension bands should be spaced approximately 12 18 apart.
Chain link fence tension band spacing.
For aesthetic reasons space posts evenly but do not exceed ten feet between posts.
1 for each rail end band 1 for each tension band 1 for every 24 of top rail and 1 for every 12 of line posts 1 for each single swing gate 2 for single swing gate 4 for double swing gate 2 for single swing gate 4 for double swing gate for each end post use 3 for.
In general use one less tension band than the height of fence you are installing i e.
Then mark your lines on the batter boards with a pencil and untie them to dig the holes.
Use flat bands for residential fence applications and beveled bands for commercial or industrial fence applications.
Carriage bolts 5 16 x 1 1 4 use 1 per tension or brace band.
Tension bands should be spaced approximately 10 12 apart.
Use 1 per tension bar holds rail end in place rail ends.
Fence tie hook ties.
If you plan on installing privacy slats or another type of material that will increase wind load consider using 8 or 6 post spacing.
Tension bar the bar used with tension bands or other post connectors to secure the fabric to a terminal post see fig.
Use 1 per tension bar.
Follow the fence manufacturer s instructions for spacing which typically ranges from 4 10 apart spacing should not exceed 10 on center.
3 42 or 4.
1 for every 12 of line posts and 1 for every 24 of top rail.
1 the good thing is that you can dig all the post holes at once.
As chain link fence posts are smaller and sturdier than many other types the holes should be smaller and can be farther apart.
A 5 high fence uses 4 tension bands per hook up.
Use 4 per tension bar or 1 per foot of fence height.
All bolt heads for bands are on the outside of fence and the threaded ends are on the inside.
The bar makes the end of the fence rigid and provides something to attach to the posts.
Mark the holes about half the width of the post away from the layout lines.
Chain link fence posts are typically spaced a maximum of ten feet apart.
Tension bands attach chain link fabric to end posts and generally projects require one band less than the height in feet of the fence being installed.
Check the manufacturer s directions for post spacing.
Run a tension bar through the links at the end of the mesh.
Lay the chain link mesh on the ground outside the fence.
Mark the posts and spacing with stakes.
Chain link tension bands are also available in brown green and black.
Same for gate posts.
We carry tension bands for both typical round tubing and also square tubing.
Use 1 for each terminal post.
Chain link fabric or mesh is usually sold in rolls 4 5 or 6 feet high.
Typical spacing is between 6 and 10 feet on center.
