Tighten nuts and bolts.
Chain link fence installation guide.
If the rails are too.
Mark the exact location of terminal post with a stake or spray paint.
1 part cement 2 parts sand and 4 parts gravel.
Dig the post holes.
Secure it in place and fill the hole around it with wet concrete.
Check all local building codes and homeowner s association guidelines for acceptable.
Chain link fence installation manual before you begin.
Find surveyors pins if the fence is to be located near property lines or have the lot surveyed.
Starting with one of your terminal posts set the post in the center of its hole and position it to a plumb position using a level and plumb line.
Mark the layout using string.
As chain link fence posts are smaller and sturdier than many other types the holes should be smaller and can be farther apart.
Measure the total length of your planned fence to determine the length of fence fabric and top rail.
Fill all the holes with 4 inches of gravel and tamp.
Add 6 inches.
Follow the fence manufacturer s instructions for spacing which typically ranges from 4 10 apart spacing should not exceed 10 on center.
Insert the rail ends into the terminal rail caps.
All posts should be set about 4 inches inside the line.
1 the good thing is that you can dig all the post holes at once.
Install the top rail 1.
You then dig a hole for each post deep enough to set it in concrete which is at least 2 feet for a 4 foot fence or you can dig shallower holes for post anchors an alternative to concrete demonstrated by diy landscaping.
Mix a fairly heavy solution as too much water weakens concrete and may cause cracking.
Chain link fence gate installation instructions figure 2 figure 3 figure 4 step 1 dig terminal post holes approximately 8 in diameter and 30 deep with sloping sides fig.
6 to 8 inches for end and corner posts 4 to 6 inches for line.
Obtain necessary zoning and building permits.
11 steps of chain link fence installation locate your property s line.
Set your posts about 4 inches away from your property line to avoid any property line issues with neighbors.
Terminal posts should be set 2 higher than the width of the fabric and line posts 2 lower than the fabric width.
Install a chain link fence preparing for a chain link fence.
Feed the top rails through the loop caps.
Mark the fence layout.
As with any diy fence project a chain link fence installation begins with laying out the fence lines and marking the positions of posts.
There may be local zoning or deed restrictions pertaining to height and type of fence.
You may need to adjust the height of the rail caps to allow for the.
Cut off excess length with a pipe cutter or hacksaw.
Set the terminal posts in concrete using a concrete mix as follows.
The exact diameter and depth will be determined by local weather and soil conditions.
Be sure to slope the concrete away from the post to allow water to run away from the base.
Step 2 with crayon or chalk mark the ground line on posts.
