Ceiling Fan Remote Control Not Working

The dip switch settings on the remote and the ones inside of the fan must be the same or there will be problems with the fan not communicating with the remote properly.

Ceiling fan remote control not working.

Check to ensure that the problem is not with the remote see fanimation remote not working guide above if the mains supply circuit. Follow the steps below to determine the cause. If the remote is sending a signal check to see if the fan and the remote are set to the same frequencies. This tells you that the fan remote control is sending a signal to the fan receiver.

Flip the switch several times to make sure it is the right. If the fan works without the remote via a pull chain or switch but not with the remote even though they have the same settings the remote has probably gone bad and you will just have to get a replacement remote. First ensure that the mains power is turned on and then check to ensure that the circuit breaker for the unit is not. If you are using a remote or.

If you have an older ceiling fan the switch may be worn out. They need to be set the same way on both the fan and the remote. If two or more ceiling fans have the same frequency they can be controlled by either fan s remote which can have a range of 40 to 50 feet. Most ceiling fan remote controls come with the factory set frequency.

Change the battery 2. Rarely another electronic device may interfere with the ceiling fan frequencies which may prevent normal operations from occurring. Once you purchase a new remote go through the necessary steps to set it up. If this is happening then the battery is ok and the ceiling fan remote is functioning in a proper way.

Below are troubleshooting steps to follow. The next possible reason why the fan is not working is to consider the remote. In this case replace the reverse switch. Contact the manufacturer 3.

They will be located on the ceiling fan receiver inside of the fan s canopy. Hence the other remote is messing with your ceiling fan. Another common issue related to dip switches is the fan turning on or off by itself. If the light is not coming on than the remote is not sending a signal.

Try a universal remote. This can usually be done by checking the dip switches. When a button is pushed on the remote a red led light should light up.